Bauer bga software11/8/2022 ![]() ![]() The only thing that's bothering me about it is that the internal fans are too loud and i think they should be off when the station is on but just idling (interestingly, they turn off completely when the station is switched in preheat/board drying mode where just the bottom plates are getting power), but i understand that adding an extra temperature sensor and control circuit for those fans would have upped the production cost and thus maybe i would not have been able to afford it, it took me 6 months to save up for it. I am happy with my Honton the way it is from the factory. With a 3-zone (especially with hot air like mine is), the IR plates play a lesser role, they are just there so large boards do not deform because of the temperature difference between the chip you are soldering and the rest of the board. From what you are saying i understand that this modification is for the bottom plates controller, for people who only have a 2-zone station. ![]() ![]() So i have two PC410s, one for the top, one for the bottom heater, and a third controller that looks like a Chinese rex-c100 but is branded Honton (the makers of the station), which controls the IR plates around the bottom heater. I have a 3-zone station, top and bottom hot air heaters. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |